Omni Post - Cut Off Holders for B and T type cutoff blades.

Cut-Off Holders accept both type "B" and "T" cutoff blades. This holder is initially setup so that it is perpendicular to the work piece and parallel to the face of the chuck. This insures that the holder will always return to its proper position (perpendicular) whenever it is removed and then replaced on the tool post. We recommend the narrow (.040") Cut-Off Holders and cut-off blades for the fastest and surest parting operations because less material is removed and less force is placed on the tool.

The height "T" for Cut-off holders is measured from the top of the compound to the top of the tool bit. For lathes requiring a height lower than those listed in the chart, grind down the top of a beveled tool bit to the necessary height. The beveled tool bit will still provide the proper side clearances.

Use Cut-Off Holders for the fastest and surest parting operations.

Fig.	Series	Part Number	Centerline Height Above Compound 'T' Min. Max.		Cut Off Blade Size	Price	Notes
P	600	8081	.675	1.575	3/32" x 1/2"	$43.50	1 *
P	600	8128	.675	1.575	.040" x 1/2"	$43.50	1 *
Q	900	8078	.875	1.575	3/32" x 1/2"	$38.00
Q	900	8120	.875	1.575	.040" x 1/2"	$38.00
Q	1200	8047	1.075	2.325	3/32" x 1/2"	$59.00

NOTES: [1] Recommended only where low minimum height is needed.
[*] Actual Height of Cut-Off blade is .476"

Cut - Off Blades

Series	PartNumber	Cut-Off Blade Size	Price **
600/900	8126	.040" x 1/2" x 3-1/2" T-type (P-1N)	$12.00
600/900/1200	8125	3/32" x 1/2" x 4-1/2" T-type (P-2)	$12.00

NOTE: [*] $10.00 When purchased with Cut-Off holder.

[ Home ] [ OMNI-POST Product Overview ] [ Free Catalog Download! ]

[ Product Series ] [ Attachment Post ]

[ Standard Holders ] [ Boring Bar Holders ] [ Carbide Holders ] [ Angled Holders ]
[ V Groove Holders ] [ Cut - Off Holders ] [ Grinder Attachment ]

[ Discounts for Sets ] [ Ordering Information ]