1) Select -

2) Select -

3) Choose -

The Post and Index Base Assembly consists of the post, index base, bolt, and T-nut unless otherwise noted. Be sure to specify the T-Nut (for 600 and 900 series holders) that fits the T-slot in the lathe compound. If the T-Nuts listed will not fit the T-slot in your lathe, select a T-Nut that is larger (dimension C) than your T-slot and machine it slightly rather than use a T-Nut that is considerably smaller than the T-Slot. These T-Nuts are unhardened and can easily be machined to size using your lathe (instructions provided). Special size T-Nuts are available on request for $15.00.

NOTE: Some machining may be necessary for the 600/900 series T-Nut.

Add quick change tool features to your small lathe!

The Low Profile Series (600 Series) OMNI-POST holders are designed for small lathes that have a centerline height (above compound ) of .450" to 1.25". These holders accept the same size tool bits as the 900 Series holders.

Myford Super 7 Lathes

Use 600 Series holders and #8058 Post and Index Base.

NOTE: you will need to order the special post and index base (shown on this page) to use the OMNI-POST System on you MYFORD Super 7 lathe.

Maximat 7 Lathes

Use 600 Series Holders and #8094 Post & Index Base (includes 8 mm Special Nut).

NOTE: You will need to order a special metric nut in order to use the OMNI-POST System on your MAXIMAT 7 lathe. The Metric nut, as shown on this page, is supplied instead of the bolt and T-nut.